I can not programme the new controller on my ep10, when I go into the prog. mode it accepts what I tell it ie 1 flash then 5 flashes to change the BEC etc voltage, I then move on disconnect the cells and recheck and it goes back to 1,1. When I try to start her up it judders and the motor and controller get hot and the head does not start turning at any point. I have tried a spare motor and battery and even been back to the shop and they gave me a new controller to try but the same happens and it does not appear to take in to memory.
I get the fast flashes when I tell it I am happy ie top stick for yes and it moves on to the next setting. Can any one help me!
Metered the brushless motor and its not down to earth or open circuit. Funny thing is it spools up under no load but when you add load it does not turn just cant decide the direction to turn in and ratchets.
02-15-2004 Over year old.
Gary Jenkins Elite Veteran Location: Wilmington, DE
You have too set the throttle curve to 0,25,50, 75,100 and the ATV should be 100% on both ends. If your throttle curve was for example 0, 65, 80,90,100 there is no mid point at half stick.
Good luck.
