zapa
Heliman
Location: Prague, Czech Republic, Europe
| Governor modeHi Hayden,
The ESC should be connected to the same channel despite iof the facts if it is in "constant rotor speed (governor) mode or not. The difference is in the tranmsitter programming.
I am using a following set-up:
idle N - linear setup (-100%,0%,100%)
idle 1 - const. set-up (70%,70%,70%)
idle 2 - const. set-up (80%,80%,80%)
Hold 20% (to bypass soft start)
All presets are additionaly mixed with knob (+/- 10%).
Usuall start-up procedure is to use N for the transport to heli-pad, switch to "1" and take-off. I can make a fine adjustment of the RPM by the knob during the flight ....
Please, keep on mind, that using the "governor mode" means that ESC is maintaining RPM itself, therefore the "throttle curve" should be flat.
... I hope I have described it in understandable form 
Best Regards
Pavel |
