Waldo
Veteran
Location: Middle of the corn patch (Iowa)
| It sounds like you need to go back to square one adjust the linkage on the tail rotor. Set your rudder ATV's to 100% both directions, next set your gain to 60% in mode 0 (normal) and mode1 (HH). Now center your rudder trims and sub trims if available on the 6Xhs, with the gyro set to 0 (normal) bring it up into a hover if the tail wants to swing left or right set it down and adjust the rudder linkage until the tail stays put when you hover, you won't get it perfect just get as close as you can. Now that your linkage is set you can experiment with the rudder ATV's to increase the piro rate and also you will need to adjust your gain settings you will probably end up around 70-80%, running to high a gain on the gyro will cause it to hunt or wag back and forth, you usually turn it up until it hunts and then reduce it until it quits. Good Luck!
Rudder ATV's adjust piro rate, channel 5 ATV's adjust gyro gain.
[b]Bill[/b] |
