ben1000
Senior Heliman
Location: Gilbert, Arizona
| I use the co-pilot on my RaptorCAM, and it works great, but it didn't set-up quite like the manual. Things will be different depending on which way the servos in your heli (Raptor 30, I think) are set-up...
Basically, I used the 'hand-in-front-of-the-sensor' method of making sure the thing was set-up right. When you put your hand in front of any sensor, the swashplate should move diagonally away from that sensor.
The manual's switch settings were wrong, so I basically tried every combination until I found the right one, then left it there...
I'll be moving the co-pilot over to an Xcell gasser this week, and will set it up the same way. Sorry if that's ambiguous, but it shouldn't take long to try every switch position (I think there are only 9 or 16 combinations)...
Hope that helps you...
- Regards,
Ben1000 |
