Bell427
Heliman
Location: St. Louis, Missouri
| Hi guys,
I just recently finished assemblying my Fury (hasnt flown yet) and something I have noticed is that they main gear is riding really low in the cutouts in front. Also, the gear mesh between the torque tube drive pinion and the inner gear is very tight. I have one thin shim between the lower bearing block spacer and the auto rotation sleeve. An additional shim would bring the gear mesh into proper tolerances, however then the main gear hits the frames and clutch plates. As it sits, the machine is runable, but I feel that something isnt right. If anyone has any suggestions as to what I might have done incorrectly, I am open to them.
Thanks,
Eric |
