davidp_aussie
Heliman
Location:
| I have just bought CC phoenix 10 esc & Hacker B20 31S. Am bench testing with servo tester (to vary throttle setting to esc). with esc programmed to heli mode, the motor is off at idle position and fully on at any other throttle position - have also tried it with radio, using straight line throttle curve - same result. as a load i'm using fixed pitch propellor (5x3 up to 6x4 inch). esc works fine in fixed or auto throttle mode (ie. proportional speed control), but in heli mode its either off or fully on - is this the way its meant to be?
i was under the impression that the stick position would set the rpm to a percentage of full rpm (ie. for straight throttle curve: 50% stick = 50% of full motor speed)
any help much appreciated
David
(Piccolo Pro) |
