ipluu
Heliman
Location: San Jose, CA
| JR 10X and GV1RX channels
Thro = GV-1 Throttle
Aux 4 = GV-1 Aux RPM
Aux 3 = gyro sensitivity - use code 44 to adjust
Gear = GV-1 on/off
GV-1
rS1 = 1550
rS2 = 1650
rS3 = 1750
SWPt = It should show On or Off depending on your gear switch postion
StSw = On or Off depending on your throttle stick position - not inhibited
Ensure you set your limits correctly - I found my idle had to be set with the stick just below 1/4 stick in order to get the governor to shut-off correctly. You need to ensure your throttle curves in stunt 1 and 2 never drop below the governor off setting - you can check this through the SWCd screen which shows the governor condition for the current switch and stick settings so play with the switches and throttle in each flight mode to ensure the screen says 'off' when you want the governor off
TX mixes
Code 51 = Gear-Aux4 (-100% +0%, no offset)
assign this to the flight modes you require by pressing the 'page' button on the mix screen
Code 52 = Gear-Aux4 (+0% +0%, no offset)
assign this to the flight modes you require by pressing the 'page' button on the mix screen
Code 53 = Gear-Aux4 (+100% +0%, no offset)
assign this to the flight modes you require by pressing the 'page' button on the mix screen
Code 44 = Auto, values are whatever gain settings you want
Assign the values to flight modes by pressing the 'Page' button
This gives me:
Auto selection of head speed with flight mode through the Aux
Manual selection of governor on/off is with Gear switch
Adjustment of head speed through Aux 4 pot
Auto selection of gyro sensitivity with flight mode
Governor shuts down when throttle output is below about 30% or using the Gear switch
Instead of using all 51, 52, 53 mixes, you could use 56 mix= #FMODE-Aux4 (-33%,0%,+33%) assign this to all flight mode |
