Vance
Veteran
Location: York ,PA
| Make sure the hovering pitch rotary knob is centered. Go to your servo output graphical display and verify that your radio is giving full servo travel, if your radio isn't showing full travel then the problem isn't the sim. Use a seperate model memory in your transmitter and change it to ppm and then do a model reset with your transmitter. I was told to calibrate the transmitter first in airplane mode with the trainer plane, then switch to the heli model and then recalibrate it.
I got tired of all the problems with my interface and have set the G2 aside until the new controller box is out that will use a USB connector that will allow you to use the dummy box or plug your own radio into the dummybox and then you can use either. It is supposed to be availabe sometime next month.
Good luck
VD |
