rcmarty
Veteran
Location: Penticton , B.C. CANADA
| Clever idea , and i'm sure it makes the second side easier.
My thought is the spindle sleeve wouldn't work correctly if it happen to be on one of the cutouts. Assuming the cuts were made in the center of the spindle.
The spindle sleeve has a tight spot right in the center that takes the loads , then the dampers do the fine bits.
Myself i use the rag with a set of plyers , for the most part the shaft comes out unscathed.
One way bearing ... brilliant IMO , thinking outside the box for sure.
Not loctite .. nuts IMO , i had a loctited one loosen up on my 600e.
Good thinking though.
Martin 
What goes up will come down.... one way or another ! |
