JEEPWORLD2002
Key Veteran
Location: BLUEBELL PA USA
| it should be listed in ur manual  but i will list them for you =)
1- throttle
2- alerion (the helis left swash servo)
3- elevator
4- rudder ( gyro in)
5- gear
6- pitch ( helis right alerion)
7- gyro sense
Now u will have set ur radio to a 3 servo swash for it 2 mix the 2 alerions and if the rt servo is moving opposite then switch the 60 on servo on that page in the tx to -60 or vesi-versa to the left alerion. the gyro wont stay lit till it recieves a signal from the tx and it will blink till u set the gyro sense over 50% for head hold on the gy 401. i would start at 65% but make sure u set 0 deg on the tail in non hold mode first which would be any thin less then 50% so i set the switch 1st position to 65 then 2nd position to 40 so when powering up the rx leave it in 1st then switch to 2nd after the gyro init's then set 0 deg and ur done so no really sure how scan select works but read the book and it will really help u. Ps on helio freak there are tons of radio set up and gyro set up u tube vids. just watch the vid of the trex 450 and radio set up. it will walk u through step by step =)
Trex600n Trex500 Mikado LoGo5003d// Hacker, CastleCreations,Ys 50, JR 7703d/8900, Radix |
