dkshema
rrProfessor
Location: Cedar Rapids, IA
| If you use the standard JR heavy duty switch harness in your arrangement, the one with all three wires -- red, orange, and brown -- you simply plug the RX battery into the harness as usual, and the end that normally goes to the RX into the Battery port labeled Batt/Bind, as usual.
Plug the supplied bind plug into the CHARGE plug that's dangling out of that harness and apply power to the RX. Then power up the TX while holding the bind button on the back "on".
The bind port on the RX simply needs to see the two outer pins of the connector jumpered together when power is applied to have the RX go into bind mode. The heavy duty switch harness with all three wires, allows you to do this.
If you have the wimpy JR switch harness that only has the brown and red wires (no orange) you'll need to plug the bind plug into the bind port of the receiver, then apply power to any other open plug on the receiver.
Don't forget to remove the bind plug when you're all through.
-----
* Making the World a Better Place -- One Helicopter at a time! *
Dave |
. Thought it was a pretty simple process, just didn't want to screw something up right off the bat.
