9387ASH
Elite Veteran
Location: UK
| power it up and make sure the blue LED is lit. Turn the Transmitter on and ensure correct modulation, have the receiver about 3 - 4 ft away from the transmitter.
Press and hold the scan button until the LED goes off and then press the button again (within 2 seconds) and release. The LED will start to flash rapidly as it scans the channels. Once it has detected a valid signal, the LED will stop flashing & remain on. Receiver should now follows the commands of the Tx.
If the LED switches to a slow flash, then it did not recognise the signal being received or it didnt receive a signal at all.
The battery level on the receiver needs to be good, the amount of times I have chased a supposed fault, only to find my pack was low !!! |
