dkshema
rrProfessor
Location: Cedar Rapids, IA
| JR rotates opposite direction from Futaba for a given stick command.
Since you replaced a Futaba servo with a JR servo, you need to reverse the GYRO direction using the NOR/REV switch on the 401 body, AND you need to reverse the RUDDER channel in the TX.
Gotta remember to reverse both the gyro AND the TX directions...
You didn't say which heli, but if it's a belt driven tail, look for loose pulleys on their shafts, or a slipping belt as the cause of your original tail wag that got worse.
Foam is a bad idea. The gyro actually needs to be somewhat rigidly attached to the heli so it can sense minute movements.
DELAY should be ZERO, this function is for slower servos, not fast ones.
-----
* Making the World a Better Place -- One Helicopter at a time! *
Dave |
Looked pretty silly.. ( I had to be sure it wasn't vibration) Even then at the low idle points the Gyro was sending a signal to the tail. Almost full throw so I decrease the sensitivity so there was not such an aggressive throw at idle but still had the violent pirouettes.
