helicraze Key Veteran Location: Victoria - Australia
Yeh the align stuff does work well (except gov mode) but sometimes just likes to go puff whenever/or wire fall out.
Aside from that, i would expect operating tolerance 10-20% but the voltage is much higher.
07-13-2008 08:45 AM
lightningrc Elite Veteran Location: UK
Even though its works , ive decided its not worth the hassle.
Im trying to get hold of the 1910H/1Y motor in the UK and also going to get the CC 85 as im worried if the esc did burn up it may then short back to the RX and cause that lot to burn up also.
But this test is confirmed as on Myth busters but not recommended.
Could you add a 2-10s BEC to the Align ESC and run 8s?
