racin06
Senior Heliman
Location: Indianapolis, IN
| As some of you know, I'm in the process of building a Super FP heli with full-separates. I understand the process of soldering both positve and both negative wire leads of the ESCs together at the battery connector.
My question is regarding the three-wire plug on the tail motor ESC. I understand that this three-wire plug, which would normally go connected to the receiver's throttle channel, goes connected to the gyro. Am I correct in saying that I must first remove both the positive and negative wires from the three-wire plug to disable the tail motor ESC's BEC leaving only the signal wire connected to the plug? Then, am I correct in saying that I connect the plug to the male three-pin connector on the Telebee gyro insuring that the signal wire is connected to the signal pin on the Telebee? Thanks. |
