rrTV-PHOTO   New HD TV
HOME   rrTV-PHOTO   GALLERIES   MY GALLERY   HELP-FAQ
myHOME PM pmRR MEMBERS 256 ONLINE 20 EVENTS SEARCH REGISTER  START HERE
 
1 page680 viewsPOST REPLY
Revolution Models . CarbonXtreme . Midland Helicopters

.
.
After Market Accessories > R30 Head Button Install Info Needed
 
 
gyan
Key Veteran
Location: Surrey, BC Canada

I bought a head button for my Raptor 30 from Gr8 Lakes but it came without the bearings in it, and the original bearings won't come out of the seesaw...sooo where do I get bearings for this??? orrr how do I remove the bearings without damage???
04-17-2003 Over year old.
 
 
K&B
Senior Heliman
Location: Columbus Ohio

Put it in the oven and heat it up to 400deg, then you can remove them.

Kevin

Sponsored by KBDD
04-18-2003 Over year old.
 
 
gyan
Key Veteran
Location: Surrey, BC Canada

400 deg??

Won't that melt the grease or affect the bearing seal in any way, or do you regrease it? & If so what with??

Thanks for your replies.
04-18-2003 Over year old.
 
 
gyan
Key Veteran
Location: Surrey, BC Canada

Anybody know if heating bearings to 400 deg will affect the lube or the seals????
04-19-2003 Over year old.
 
 
Al Magaloff
rrMaster
Location: 12,199 Posts- Enough Time Wasted. See Ya!

There are no seals, and you will have to re-grease the bearings.
04-19-2003 Over year old.
 
 
PAUL-HILLMAN
Senior Heliman
Location: palatka -florida

just removed mine . here a way to remove them with out heating them. put the sea-saw in vice not to tight . and if you have a old fly bar rod just barely bend the end about quarter inch from bottom. put it in the sea saw and check top see if it hits the other bearing then just take a harmmer and tap it out. makeing sure the seasaw does not move. they'll come right out. spray 10 w 40 in the seasaw before you start.
04-19-2003 Over year old.
 
 
1 page680 viewsPOST REPLY
HeliProz . ZoomsHobbies . HeliHobby

.
.
After Market Accessories > R30 Head Button Install Info Needed
 PRINT TOPIC Advertisers 

Subscribe to This Topic

Saturday, November 22 - 9:36 am - Copyright © 2000 - 2008 runryder.com | email | link to rr | runryder needs cookie