RunRyder - Magnets for MultiGov

rrTV-PHOTO

New HD TV

HOME rrTV-PHOTO GALLERIES MY GALLERY HELP-FAQ

myHOME PM pmRR MEMBERS 260 ONLINE 20 EVENTS SEARCH REGISTER START HERE

1 page

172 views

POST REPLY

HeliProz	.	ZoomsHobbies	.	HeliHobby
	.		.

Radio - Servo - Gyro - Gov - Batt > Magnets for MultiGov

Zerofreak
Heliman
Location: Tórshavn, Faroe Islands, Europe

Hello

Can anybody tell me witch other brands (TJ-Pro/RevMax etc.) other than MultiGov Magnets will work with a MultiGov Governor?

Never give up!

06-23-2008 03:59 PM

HOMEPAGE

tgo
Senior Heliman
Location: HK

I have Futaba GV1 magnets for MultiGov.

06-23-2008 04:15 PM

artimus
Veteran
Location: Puyallup WA

Any magnet should work....just make sure that you have the the right side of the magnet up and close enought for the sensor to read it.one side is + the other is -

AMA #890376..... Flying Helis is like sex ...you dont have to be good at it to enjoy it....

06-23-2008 04:21 PM

Zerofreak
Heliman
Location: Tórshavn, Faroe Islands, Europe

Ok, thank you very much for helping.

Never give up!

06-23-2008 04:59 PM

HOMEPAGE

realwiz
Senior Heliman
Location: Medina, Ohio, USA

Does the polarity match up between the Throttle Jockey Pro and the Multigov Pro? I want to replace the Throttle Jockey in my Heli with a Multi Gov, and I want to know if I'm going to have to flip the magnet. Thanks.

06-25-2008 12:12 PM

HOMEPAGE

tchavei
rrProfessor
Location: Portugal

If you have two magnets facing opposing directions than you don't even need to think about it as the multigov will pick up only one of them. If you only have one magnet and it was working with the throttle jockey there is a good chance that it will work with the multigov since I know as a fact that it works with the revmax polarity. Since revmax and the throttle jockey pro are both made by Model avionics, it should be a no brainer

TOny

--------------------
"Perfection and patience usually walk side by side..."

06-25-2008 12:59 PM

HOMEPAGE

realwiz
Senior Heliman
Location: Medina, Ohio, USA

Thanks. That will save me some work.

06-25-2008 05:03 PM

HOMEPAGE

artimus
Veteran
Location: Puyallup WA

It just how the sensor reads the magnet....either the + pole or the - pole.....if you use both magnets it gonna read one of them.

AMA #890376..... Flying Helis is like sex ...you dont have to be good at it to enjoy it....

06-25-2008 08:34 PM

artimus
Veteran
Location: Puyallup WA

When installing new magnets I will take the magnets when they are stuck to each other and mark the out side of each with a magic marker . This will give you one positave and one negitave...just install them with both marked sides facing the same direction.

AMA #890376..... Flying Helis is like sex ...you dont have to be good at it to enjoy it....

06-25-2008 08:41 PM

1 page

172 views

POST REPLY

Ron’s HeliProz South	.	Century Helicopter	.	MTA Hobbies
	.		.

Radio - Servo - Gyro - Gov - Batt > Magnets for MultiGov

PRINT TOPIC

Advertisers

Subscribe to This Topic