RunRyder - Blade 400 3D What could be the Problem?

rrTV-PHOTO

New HD TV

HOME rrTV-PHOTO GALLERIES MY GALLERY HELP-FAQ

myHOME PM pmRR MEMBERS 408 ONLINE 42 EVENTS SEARCH REGISTER START HERE

1 page

344 views

POST REPLY

HeliHobby	.	Ron’s HeliProz South	.	Century Helicopter
	.		.

e-E-Flite Blade CP CX 400-3D > Blade 400 3D What could be the Problem?

StevenT
Senior Heliman
Location: Dallas, GA USA

The last two times I tried to go inverted, my heli (Blade 400) dumps hard to the left and I was not able to recover either time. I would think that I was inputting right side roll accidentally, but on the sim I've never had an issue. Also, I was very high and not able to recover either time.

I don't believe that it is in the set up. What else could it be? Just as I went inverted I input full negative pitch, which I know is a problem and have corrected that, but it still doesn't explain why it dumps to the left (my left, helis right). Can a pitch control rod pop off and cause the right side roll with hard inputs? Has anyone else had a similar problem?

Thanks for any help.

Steven

Shhh, don't tell the wife.

06-05-2008 11:14 PM

stickyfox
Key Veteran
Location: Troy, NY, US

Is your swash plate mechanically centered? i.e., when it's level, are the servo arms also level? The servo horns should look like mirror images. If they're not, you will be mixing unwanted cyclic into your collective.

-fox

06-07-2008 02:11 AM

HOMEPAGE

Wingman77
Key Veteran
Location: Pulaski TN US

umm, you do have your throttle hold set up right? how much do you know about setting up the head? starting with the servos at 90 then the swash must be level and all the arms should be at 90 degrees then the blades should be at 0 pitch. make sure the swash goes the same ammount up and down.

oh I know what could make it pitch to one side also, it could very esialy be the travel adjust make sure the travel adjust + is the same for all three servos and make sure the - is also the same.

06-07-2008 02:23 AM

1 page

344 views

POST REPLY

MTA Hobbies	.	Model Rectifier Corp	.	RCHover
	.		.

e-E-Flite Blade CP CX 400-3D > Blade 400 3D What could be the Problem?

UPDATE SCREEN PRINT TOPIC

Advertisers

Subscribe to This Topic