RunRyder - gear meshing

rrTV-PHOTO

New HD TV

HOME rrTV-PHOTO GALLERIES MY GALLERY HELP-FAQ

myHOME PM pmRR MEMBERS 316 ONLINE 26 EVENTS SEARCH REGISTER START HERE

1 page

394 views

POST REPLY

Mikado Modellhubschrauber	.	GrandRC	.	CanoMod
	.		.

Avant Aurora - EFX - FX > gear meshing

trickytiker
Senior Heliman
Location: england

if i mesh the gears in the tail as instructed thay seem a bit rough
does this improve with use

06-01-2008 05:49 PM

bob00
Veteran
Location: Toronto, ON

trickytiker,

If it's rough in one or 2 spots but smooth with zero backlash everywhere else then...
- it sounds like your mesh is good and they will run smoother after a while.

If it's rough all the way around and the gears are properly engaged as shown then...
- try removing 0.1mm from both shafts - if they run smoother and still without backlash then you're good

- Rob
teambob00 / FlightPower / Avant / Spartan

06-01-2008 06:14 PM

HOMEPAGE

trickytiker
Senior Heliman
Location: england

o/k will do its the depth of the gears if i have them at the depth
in the pics thay tend to be rough all round, i am a watchmaker
the teeth on watch wheels and pinions tend to a differant
shape and run smoother with less friction

06-01-2008 06:30 PM

mickeyapples
Veteran
Location: England

Mine where stiff so I ended up loosening the bolts to the tail and clutch, then spinning the main gear, then do up the bolts and check alignment. result was much smoother gears with no play. going to repeat this when the engine is fitted.

Live life on the edge. Stand next to me when I am flying

06-03-2008 12:24 PM

1 page

394 views

POST REPLY

Futaba-RC	.	A Main Hobbies	.	Boca Bearings
	.		.

Avant Aurora - EFX - FX > gear meshing

UPDATE SCREEN PRINT TOPIC

Advertisers

Subscribe to This Topic