TheBigNoob Heliman Location: Sherwood Park, Alberta,Canada
Hi all...I am using G3.5 and cannot figure out how to dial down the sensitivity of the sticks....I own a T-Rex 450 SA and would like to have my interlink controller set up to be as much like the actual radio as possible...If I move the sticks 2 mm in any direction I get a major response...I am not sure where I need to go to set up the sensitivity...On another note does anyone know if there is an actual T-Rex 450 available for a Real Flight sim...Thanks for your help
"How many times must I crash before I learn"
06-01-2008 01:38 AM
TheBigNoob Heliman Location: Sherwood Park, Alberta,Canada
Does anyone know anything about this or do I just need to learn to live with it?...Thanks guys
"How many times must I crash before I learn"
06-01-2008 04:18 PM
n8tivedave Senior Heliman Location: simi valley,cal,u.s.
3.5you could start by going to settings, and turn the physics down, should slow it .
if at first you dont succeed,buy,and fly again
06-01-2008 05:01 PM
MJA Key Veteran Location: Cumbria-UK
You can use/set different dual rates and exponential values with the Interlink controller.The dual rate switch is the front top left one. To setup the dual rates and expo for any loaded model you need to select Aircraft from top menu bar then Edit the model you have loaded.Go into Software radio and press the plus sign to expand it's tree and change the values for output channel 1,2,4 (cyclics and rudder).You can change the low/high rate values and the exponential values for rated and unrated switch setting of the interlink controller.Then save the new settings with a new name of your choice .It's best to keep the model name and just append the end eg Dominion-moreexpo or whatever The software radio editing works on a per model basis rather like a model memory on a real tx.
The nearest Realflight offering to a T-Rex 450 is probably the MX400 on expansion pack1,not sure if there is 3 rd party ones on the net or not.
yup....on the realflight swap pages get the t-rex 450se v2 stock config (i found it as a variant on the performance model). Then go into setup and click on software radio, then adjust low rate expo on channels 1 and 2, start about 50 percent and adjust up or down according to your taste. That will definately tone it down a bit. I was able to get a locked in rock solid hover at 40 percent expo. Good luck!
Andy T-rex 450sa, Axe CP
06-08-2008 02:19 AM
TheBigNoob Heliman Location: Sherwood Park, Alberta,Canada
