jjchoe
Heliman
Location: irvine, ca usa
| You mentioned that this problem happens when the stick is above the half way point. When you installed your new 4 in 1 did you route the antenna wire the same as the original. It sounds as if it is either the 4 in 1 or radio interferance from the motor. Try to disconnect the motors (main & tail) then turn on transmitter and plug in battery, leave the transmitter antenna down and start to fiddle with the controls while slowly walking away. If the glitching occurs imediatly then try to undo the antenna on the receiver and lay it strait, make sure the antenna is away from any power wires (battery plug. Then repeat test. I have a BCCP with the super skids, if i run the antenna on the left side of the skid (where the antenna tube mount is located, i don't know why they put it on the left side) i get glitches at high rpms (when left tranmitter stick is in the upper position) So I just wrapped the antenna from the receiver on the right side of the skid, original location on a stock BCCP. Problem is gone. Try not to have the Antenna around any other wires (battery wires , plug, servos wires, etc.) Sorry for the long post. My background FYI, is many many to many to count with RC cars, raced in large races like the Reedy Race, i just got into heli, since driving my cars in front of my house by my self is no fun, and cleaning it afterwards is not worth the little enjoyment i get. So i decided on heli and, fly helis in front of my house by myself is tons of fun, since its such a challenge, since 1 crash = back inside the house to get the keys to drive to the hobby store. |
....waayyy better machine
