jakeg1999
Senior Heliman
Location: Bonita, CA
| Hey Ink beginner question here....how do I adjust the phasing of the driver? Is it just by raising it up and down? Right now the arms are level or parallel to the swash at mid stick/ 0 pitch.......I just hooked it up to the computer, and there does not seem to be any interaction when I move the collective at all...I don't think mixing in elevator at the endpoints is the solution, as it only happens on a hard collective punch. It really only happens on positive punch and not negative....Kind of annoying though, because tic-tocs are just about impossible to keep steady as the nose pitches towards the blades. It's almost as if the elevator servo is not keeping up with the stress of the collective punch...I am running a ton of pitch +-15, but it does it obviously way before I ever get to that high of pitch....I have the stock gyro foam on there right now, and it seems a little too spongy. I am going to try some of the zeal gel tape right now....Then I was thinking of messing with the AOF settings, right now it's stock or set to the 600 size heli setting, and I am flying the Trex 500. There is a selection for the Logo 500, so maybe that would be better...I also read that some folks had more success by just deactivating it....either way I am off to the field to try some things....Thanks for your help...oh I did have one question as far as your 600N setup. I had heard from a couple folks that the Vbar is a little finicky with the 600N due to vibrations....Did you have any issues with this? Thanks again.... |
