michaelf
Heliman
Location: Adelaide, South Australia, Australia
| Has anybody had any bad experiences using the Jazz 40-6-18 with outrunner motors?? On two occasions I have burnt out JGF500T outrunner motors. This happened after about three to five minutes of flight at hover under very little load. Both motors have been looked at by JustGoFly, and I was told it wasn't the fault of the motors. The 40-6-18 was purchased this year, so I am assuming it has the latest firmware. The equipment was being used in the Twinn Rexx heli.
Looking forward to some feedback.
Michael |
