FlyinBrian
Veteran
Location: USA
| Hi,
Go to the MDL screen and pick FNC, now pick the gyro channel 5. Assign the TRM (Trim) to null and assign the CTL (control) to null (removes it from the switch). Go to the condition screen and pick pmix one and set it up as follows
Active (make sure you set the switch to null so you can't accidently turn the mix off)
ch 6 slave
ch 5 master
linear mix
trim off
push Nxt and set the mixing % to 100% on both sides
Now go to the sys menu and pick the servo monitor and you should see that ch5 follow's ch6 exactly (if its backwards then reverse ch 5)
Make sure you setup the mix for each flight mode or you may get a surprise...... |
