rrTV-PHOTO   New HD TV
HOME   rrTV-PHOTO   GALLERIES   MY GALLERY   HELP-FAQ
myHOME PM pmRR MEMBERS 743 ONLINE 73 EVENTS SEARCH REGISTER  START HERE
 
1 page89 viewsPOST REPLY
HeliHobby . HeliProz . Ron’s HeliProz South

.
.
e-MS Composit Hornet > tail gearbox gears lash
 
 
thtoyman
Senior Heliman
Location: Gone ,Flying.Mich

Any one know how to set lashing? What I'm look for is how to do it. My lashing way off. So how dod I move the gaers over?
04-26-2008 04:15 PM
 
 
RUSH
Heliman
Location: Los Angeles, CA

On the Hornet, you set the tail gear lash by moving the gearbox on the tail boom. Loosen the set screw and move the box forward or back until you get just a little bit of play in the gears, then tighten the screw. I hope this is the info. you're looking for.
04-26-2008 09:46 PM
 
 
thtoyman
Senior Heliman
Location: Gone ,Flying.Mich

Not seeing any set screw. I look agian. thanks will try it.
04-27-2008 03:06 AM
 
 
RUSH
Heliman
Location: Los Angeles, CA

Sorry about that, I wasn't as complete with my information as I should have been. On the older hornets, there is a set screw that goes into the the tail gearbox right in the middle (on the round part). On the Hornet II and X-3D, the tail box has a bolt and nut that is off to the side of the round part which clamps the tail box to the boom.
04-29-2008 12:45 AM
 
 
1 page89 viewsPOST REPLY
Century Helicopter . RC-Direct . MTA Hobbies

.
.
e-MS Composit Hornet > tail gearbox gears lash
  UPDATE SCREEN   PRINT TOPIC Advertisers 

Subscribe to This Topic

Wednesday, May 14 - 4:54 am - Copyright © 2000 - 2008 runryder.com | email | link to rr | runryder needs cookie