RunRyder - Setup Help needed

rrTV-PHOTO

New HD TV

HOME rrTV-PHOTO GALLERIES MY GALLERY HELP-FAQ

myHOME PM pmRR MEMBERS 329 ONLINE 42 EVENTS SEARCH REGISTER START HERE

1 page

209 views

POST REPLY

Revolution Models	.	CarbonXtreme	.	Midland Helicopters
	.		.

Compass Knight 50 > Setup Help needed

karman
Senior Heliman
Location: Cape Town, South Africa

Hi all

need some help please...

2 things: The clutch that comes with kit screws onto the shaft (most other installes instruction i can find slide on). do i simply hand tighten it on, then lock it with nut,or do i need to tighten it hard, then lock with nut?

2:. Should there be gasket between muffler and motor?.

thanks
L:

04-10-2008 07:20 AM

Adey_Law
Senior Heliman
Location: Bournemouth, UK

you need to screw it in hard (oooh err) then lock it on with the nut.

no gasket required on the exhaust.

Ade

04-10-2008 07:24 AM

karman
Senior Heliman
Location: Cape Town, South Africa

thanks!!!

you guys must be living on runryder ;-)....

another week or so, and she'll have her maiden!!!

L:

04-10-2008 07:34 AM

The Old Guy
Senior Heliman
Location: UK Surrey

Also, DO use licktite on the nut but not on the clutch.

04-10-2008 09:27 AM

HOMEPAGE

karman
Senior Heliman
Location: Cape Town, South Africa

loctite on nut done, non on clutch.....
need to get new bottle of loctite.. man, never used so much loctite in my life ;-)

L:

04-10-2008 09:53 AM

karman
Senior Heliman
Location: Cape Town, South Africa

cyb Solid G gyro

ehlo again

Anyone running a Solid G on there knights?

if so, which model is recommended, and did you change any of the other default settings?

thanks agian
L:

04-10-2008 12:45 PM

The Old Guy
Senior Heliman
Location: UK Surrey

04-10-2008 01:09 PM

HOMEPAGE

centuryman
Veteran
Location: deerriver,mn usa

If your question is whitch to use? the red for your clutch nut because it can be heated to remove.other wise on your 3mm screws blue is suffeciant and can be remove without heat. However on 2mm scews you need red because of the size the blue will not hold.Also make sue the threads on both parts are clean.A shot of contack cleaner will do the trick.Allow 16 hours to fully cure.If your in a hurry ca glue works but can be tough to remove.

04-10-2008 01:17 PM

The Old Guy
Senior Heliman
Location: UK Surrey

No question, just being silly re size of container!!!!!!!!!!

04-10-2008 02:27 PM

HOMEPAGE

karman
Senior Heliman
Location: Cape Town, South Africa

loctite

been using red for "permanent" bolds.. and blue for temp bolds...

i need one of those bottles!! hehe

04-10-2008 02:45 PM

1 page

209 views

POST REPLY