Whell guys yesterday i fly F3C program with my X-cell Graphite in the 7th tank suddenly i see rotor head go away without helicopter !!!!!!!! off course the heli is come down and the rotor do a cycle and after that land very good and the most strange i do not have any serious damage only two lost ball links and the fear i feel when i see what happen
Seen it Happen Before.....Check to see if the retaining pin is still secure in te head with the set screw. If it is whoever put the head on missed the main shaft and put the pin in actually on top of the main shaft. It will fly for a while with the clamping screws on the head block but at some point the head will depart from the Heli. I always line up the hole in the head block with the main shaft then I turn it one revolution just to make sure that I am seeing the hole in the main shaft. Then I insert the reatining pin then I try to pull up on the head to make sure it's secure before I tighten the clamping screws on the head. It is an unusual sight to see the head go one way and Heli go the other!
Fury Flyer Always check that screws never let it without see it before flying but i believe its a strange feel to see rotor head go away and you can do nothing just see it in my luck i do only hover for F3C and not go to acrobatics i fly again the same helicopter today no problem at all
