pequeajim
Veteran
Location: New Holland, PA
| I found out that the instructions for the counter gear assembly tell you to install a supplied o-ring and this is incorrect and should be ignored.
The counter gear assembly goes together fine without the o-ring.
I ran into another problem that I am wondering if you guys encountered.
First, the brass gear does not match up fully with the main gear. It site about 3-4 mm too high. THis could be because the holes cut in the frames are wrong as they do not line up with both blocks at the same time. I installed the screws into the upper block, so for the heck of it, I will try the lower. Either way, I can not screw all 4 into the upper and lower blocks at the same time as the holes are off on the frame.
Any of you guys see this? What did you do?
Jim! |
