haggy38
Senior Heliman
Location: Bogotá - Colombia
| This is just like an advice if in your fiel have more than one 2.4 Fast systems.
I would make the following recommendations.
Get all 2.4 FASST systems in your club together and carry out the following test.(From heli-freak)
Switch on your TX and all other RX’s, see if any other system will respond, if not then repeat with all other TX’s one at a time. Remember, only 1 TX at a time.
What this will do will show that all the TX’s in your club are not interfering with each others rx, therefore you do not have more than ONE faulty TX present. However if a new TX or module turns up then you MUST repeat the test, because one of your TX’s may have been faulty but it would not show unless 2 or more are present. (Bit of a pain but you can at least continue with safety until Futaba give a heads up on this and resolve/replace the faulty TX’s.
We have done this in our club now and are back flying as normal.
Sorry to be the bearer of this news but for safety’s sake you should know, and with a little checking (as indicated) you can still fly non-faulty units with each other perfectly safely.
Regards,
Gustavo |
