Richard
Veteran
Location: Scottish Borders, U.K.
| I am building Uni 2000 mechanics fitted with a O.S. SX-HG engine.
I seem to have a couple of problems ?
1. The engine mounting instructions states ( I am using the 14mm pinion)•
If you are using a metal clutch bell with a 14 mm pinion, the lower threaded holes in the motor mounts must be 16 mm from the bottom edge of the motor mounts; if that is not the case, swap over the right and left motor mounts.
Is the above measurement from the botttom of the engine mount to the bottom of the threaded holes or to their centre ?
2. When I slide the Fan shroud down onto the air duct, the shroud sits approx 2mm above the upper struture so as the holes for bolting them together do not match up.
What am I doing wrong ?
Richard
 |
