Dagger
Heliman
Location: Ottawa, Ontario - Canada
| Hi DarkHorse1,
I purchased the DUZI gear (picture attached). This gear replaces the main conical gear that comes with the kit and allows the flyer to re-position the motor from the front of the helo to the rear and also allows the flyer to use the Twister or AXI motors. The DUZI gear is much smaller than the original stock gear. The original main gear is attached by sliding the shaft throught the bearings and into the conical gear and is held in place via a small pin. The DUZI gear however is held in place via a small collar below the gear itself. The problem is that the shaft appears not to be long enough to provide the proper pitch range. I need another few millimeters to get the required pitch. I am guessing that I need a longer main shaft. 
 |
