RunRyder - Another question... Tail hub..

rrTV-PHOTO

New HD TV

HOME rrTV-PHOTO GALLERIES MY GALLERY HELP-FAQ

myHOME PM pmRR MEMBERS 725 ONLINE 42 EVENTS SEARCH REGISTER START HERE

1 page

274 views

POST REPLY

Real Raptors	.	Mikado Modellhubschrauber	.	GrandRC
	.		.

Synergy R/C Synergy N9 > Another question... Tail hub..

NOLONGERFLYING
Veteran
Location: Scottsdale, AZ

Another question...

Has anyone had any problem with the bearings and the small part of the thrust bearing fitting onto the tail hub? Any tricks to this? The fit just seems VERY tight and I dont want to force the hub through the bearing into the grib and to the small part of the thrust bearing.. This is on page A23... Anyone have this issue or has the bearing and the small part of the thrust bearing fit good for you all?

If you dont succeed the first time, try and try again. With heli's keep on trying!

08-13-2006 Over year old.

harveyhugo
Senior Heliman
Location: Cheshire, UK

Mine was also very tight and I was concerned I might deform the thrust washer. However all was ok I just put the thrust bearing together then pulled it down onto the tail hub shaft using the bolt and washer. Hope this helps.

Going to fly mine for the first time today

2 x Trex 600N, 2 x Synergy N9

08-13-2006 Over year old.

HOMEPAGE

NOLONGERFLYING
Veteran
Location: Scottsdale, AZ

Mise well

I mise well try, if it is too small, I will need another one anyways

...Thanks

If you dont succeed the first time, try and try again. With heli's keep on trying!

08-13-2006 Over year old.

DOKEY
rrProfessor
Location: Northampton UK

How about trying to polish the hub up a little to try and make the thrust bearings slide on a little easier, may take a little less stress of them while installing?
Mine slipped on, as if it is a precision fit

Check the gallery!

08-13-2006 Over year old.

HOMEPAGE

NOLONGERFLYING
Veteran
Location: Scottsdale, AZ

Greased

I have greased them down and what not, dont have a lathe(sp?), so I am just hoping now, I shall find out within an hour when I finish up the build how it all goes. Only the tail, and torque tube bags left after this part! Of course then I need to trim all the mechnical/electircal stuff out. Sure enough with the spirit of it, it is raining out here

If you dont succeed the first time, try and try again. With heli's keep on trying!

08-13-2006 Over year old.

1 page

274 views

POST REPLY

CanoMod	.	Futaba-RC	.	A Main Hobbies
	.		.

Synergy R/C Synergy N9 > Another question... Tail hub..

UPDATE SCREEN PRINT TOPIC

Advertisers

Subscribe to This Topic