RunRyder - Hornet II Main Blades hitting tail rotor blades

rrTV-PHOTO

New HD TV

HOME rrTV-PHOTO GALLERIES MY GALLERY HELP-FAQ

myHOME PM pmRR MEMBERS 573 ONLINE 45 EVENTS SEARCH REGISTER START HERE

2 pages [ << < 1 ( 2 ) > >> ]

1326 views

TOPIC CLOSED

HeliProz	.	ZoomsHobbies	.	HeliHobby
	.		.

e-MS Composit Hornet > Hornet II Main Blades hitting tail rotor blades

Micro-Maniac
Elite Veteran
Location: Pasco,Washington Formerly: Captain Chaos

Um, madcratebuilder..

From where to where did you measure the H2 boom? I think your 11in is from where it exits the frame instead of it's full length from gear to gear.

02-22-2006 02:20 AM

duenaz
Heliman
Location: Colorado Springs, Colorado USA

i've got 258-260mm blades. I ordered the right tailboom and driveshaft. Thanks guys

02-22-2006 02:21 AM

pcdonovan
Heliman
Location: Miller Place, NY

X3d and HII use the same e416 boom

I'm not madcratebuilder but.. I have the answer... do I get a prize
haha

also if I'm not mistaken the OD on the tailboom is closer to 7.5mm

Hornet II

02-22-2006 02:21 AM

duenaz
Heliman
Location: Colorado Springs, Colorado USA

tailboom for H2 is 7.6mm pretty close there pcdonovan.. ever since I found out I had the wrong stuff i've been researching like crazy.

02-22-2006 02:36 AM

pcdonovan
Heliman
Location: Miller Place, NY

http://www.mscomposit-usa.com/shopo...ocs/manuals.php

Here are the manuals in pdf. for all of the hornet range you have seperate instructions and drawings for each. Great site to book mark. I have already started to install X3d parts on my H II if any of you guys have the plastic hiller, and have had the little posts break away from the hiller main section, use the X3d part the hiller mixer arms attach via bolts no more plastic crap post and ca'ing that little rubber grommet. Its a direct replacement.

Hornet II

02-22-2006 02:40 AM

Blade-X
Senior Heliman
Location: Singapore

:Heard that.... I did try to go back to my LHS to try to exchange the old one with the plastic posts for the new x3d bell-hiller head.. but to no avail...

02-22-2006 05:03 AM

madcratebuilder
Heliman
Location: Northern Orygun USA

Captain Chaos, you are correct I measered frame to rear gear.

pcdonovan, my H2 boom is 7.57 when I bother to get the dial calipers out. I was eyeballing it.
The point is the h2 boom is about 1in longer and 1mm larger in diameter.
Obviously larger than the Hornet fp, cp or cpx.

02-22-2006 05:37 AM

HOMEPAGE

2 pages [ << < 1 ( 2 ) > >> ]

1326 views

TOPIC CLOSED

Ron’s HeliProz South	.	Century Helicopter	.	MTA Hobbies
	.		.

e-MS Composit Hornet > Hornet II Main Blades hitting tail rotor blades

UPDATE SCREEN PRINT TOPIC

Advertisers

Subscribe to This Topic