RunRyder - Pitch settings for the Caliber .30

rrTV-PHOTO

New HD TV

HOME rrTV-PHOTO GALLERIES MY GALLERY HELP-FAQ

myHOME PM pmRR MEMBERS 474 ONLINE 19 EVENTS SEARCH REGISTER START HERE

1 page

527 views

POST REPLY

GrandRC	.	CanoMod	.	Futaba-RC
	.		.

Kyosho Caliber 30 & 60 - Concept - Nexus > Pitch settings for the Caliber .30

wgeffon
Heliman
Location: Bloomington, Illinois

What numbers are you guys using for pitch curves.

Normal mode?
Stunt Mode?

10-05-2002 Over year old.

limey
Senior Heliman
Location: Pittsburgh,PA

I use -10 to +10 in all flight modes, although I am looking to increase this as my engine is packing too much power. (Can you ever have enough

)

Currently my throttle curve goes something like 0 - 20 - 30 - 45 - 100 in normal mode, which is why I think I might get away with more pitch!!

All the best,
Steve.

10-06-2002 Over year old.

mrNoodles
rrProfessor
Location: Borlänge, Sweden

Have to ask you limey:
Is it set up as manual shows? Mine is (I think

) but I dont get it.
I wants to have a linear 0 - 100 curve in idle up2 with +/-10 at ends and 0 center.
But when setting it up as manual says I gets something else

Any ideas?

Just read the other thread about shortening the links to the blade grips - I´ll give it a try

/Fredrik
'Hm now I just have to find out where to connect the GV1 sensor to the Jazz80 ESC.

10-06-2002 Over year old.

HOMEPAGE

limey
Senior Heliman
Location: Pittsburgh,PA

You got it, it was about shortening those links which made all the difference. I then centered it at dead stick so I had 0 in the center and then full positive and full negative will be the complete opposite of each other. I also had move the guide on the main shaft up a little way so it didn't bind.

The swash AFR I believe is set to -60, -60 +40 and I am running in CCPM mode and you may have guessed.

Best wishes,
Steve.

10-06-2002 Over year old.

mrNoodles
rrProfessor
Location: Borlänge, Sweden

Thx limey.
Will check it out tomorrow eveing

How much did you shorten the rods?

/Fredrik
'Hm now I just have to find out where to connect the GV1 sensor to the Jazz80 ESC.

10-09-2002 Over year old.

HOMEPAGE

limey
Senior Heliman
Location: Pittsburgh,PA

Just a couple of mm's off the length of the shaft and 1 mm off the end of each of the ball links.

I actually chopped slightly more than this off as I couldn't believe it would need so little, now I have a fair amount of gap between each of the ball links.

Steve.

10-09-2002 Over year old.

mrNoodles
rrProfessor
Location: Borlänge, Sweden

Thx

/Fredrik
'Hm now I just have to find out where to connect the GV1 sensor to the Jazz80 ESC.

10-10-2002 Over year old.

HOMEPAGE

1 page

527 views

POST REPLY

A Main Hobbies	.	Boca Bearings	.	Modefo's RC Helicopters
	.		.

Kyosho Caliber 30 & 60 - Concept - Nexus > Pitch settings for the Caliber .30

PRINT TOPIC

Advertisers

Subscribe to This Topic