darkfa8
Key Veteran
Location: Eatontown, NJ, USA
| I thought it was time to post this mod since I've had it for a while. It was performed by the previous owner's friend who was a JR rep.
The parts you need are for a JR Vigor CS. This includes the complete tail rotor center hub, o-rings, washers, thrust bearings, radial bearings, lock nuts, tail blade holders...
The parts blow-up can be seen on page 35 of the Vigor CS manual
http://www.horizonhobby.com/ProdInf...9051-manual.pdf
The JR tail center hub fits right on the stock T50 tail output shaft.
You can make them out on my T50 in my gallery pictures.
Enjoy 
- Dan G. - |
