gyroman
Senior Heliman
Location: Pasadena, CA
| My recommendation is to come up to California for a day or two and have Todd Bennett setup your machine, you will have a machine that flys hands off , and by the time you go back your 3D skills will be awesome,
But anyway about the clutch plate, I had the problem too, I put the bolt in the upper holes of the plate, you have to drill the block though.
Your other problem may have been that you got an older kit and you don't have the updated clutch. if your kit came with aluminum plates then send your clutch back, it is a free upgrade.
See ya, |
. My clutch plate is carbon and I still having problems with the whole system. First I used the upper holes of the plate to set the cluth bell in place, the gear mesh was destroyed after two flights, then I used the lower holes and the urethane dampeners burn after one flight!!! Let me tell you that the few times I have flown it, itīs amazing, but I need help. For each flight I spend almost two hours fixing a problem.
