rrTV-PHOTO   New HD TV
HOME   rrTV-PHOTO   GALLERIES   MY GALLERY   HELP-FAQ
myHOME PM pmRR MEMBERS 443 ONLINE 42 EVENTS SEARCH REGISTER  START HERE
 
1 page283 viewsPOST REPLY
CanoMod . Futaba-RC . A Main Hobbies

.
.
JR Heli Vibe - Airskipper - Sylphide - Venture > Paddle problems with Ergo 46
 
 
Extra3d
Heliman
Location: Indiana

Hello,
I've been having alot of problems with my paddles turning on my Ergo, the last couple of time's this happend I had to hold almost full up elevator just to keep the heli level to get it back on the ground, if I pull out hard doing anything the paddles turn, I had a stock set on there at first and then a couple days ago I switch to a new 3D set off of a Venture there going to work great if I can get the turning to stop, I thought about Loctite but I thought I'd better ask before doing anything?
Thanks David
09-05-2002 Over year old.
 
 
ScottG
Veteran
Location: Ft. Wayne, Indiana

Loctite may react to the plastic paddles, you might try slow cure epoxy.

Scott

What part of " Shall Not Be Infringed" do you not understand...??
09-05-2002 Over year old.
 
 
Lwnemesis
Senior Heliman
Location: Seattle, WA

or SuperGlue
09-05-2002 Over year old.
HOMEPAGE  
 
 
MobileRaptor
Veteran
Location: Orange, Texas

Been Their, Done That

About two months ago after a fresh set up, after about three tanks hovering just to make sure everthing was running good. I did a few twenty foot jumps just to check power, it was great. I did a full power climb out and at 60 70 feet the helicopter trim drastically changed. seems like I had the stick in one corner and the best I could do was a slow circle working away from me. the chopper kept moving away so I backed out of he throttle/pitch and the blades basically stop and fell 40 ft to the ground.

One of the paddle had turned 90 degrees. damage was boom (it landed on the tail) feathering and main shaft, blades were fine. I'm now running a Raptor fly bar and KSJ paddles.
09-06-2002 Over year old.
 
 
Extra3d
Heliman
Location: Indiana

I ended up drilling the holes in the Venture paddles a little deeper with a smaller drill bit, enough to turn the blades a extra turn or so, they really tightend up. I flew it today and put some extra hard loads on it, they did'nt move at all, hopefully things stay that way.
09-08-2002 Over year old.
 
 
1 page283 viewsPOST REPLY
Boca Bearings . Modefo's RC Helicopters . XHELI.COM

.
.
JR Heli Vibe - Airskipper - Sylphide - Venture > Paddle problems with Ergo 46
  UPDATE SCREEN   PRINT TOPIC Advertisers 

Subscribe to This Topic

Friday, September 5 - 12:16 pm - Copyright © 2000 - 2008 runryder.com | email | link to rr | runryder needs cookie