I am building the Falcon 50 using the OS 50 engine. The clutch/pinion gear has two bearings in it, top and bottom and both are the same size (12mm x 18mm). The ID of the clutch bearings are 12mm. But the OD of the engine crank shaft is only 10mm. Am I missing something here? Is there supposed to be a spacer supplied to make up the difference? Is the bottom bearing the wrong size? Anybody else seen a problem here or know the solution? Thanks!
07-07-2002 Over year old.
kevlar11 Senior Heliman Location: Edmonton
bearingsUse the clutch Luke...... use the clutch. KD
07-07-2002 Over year old.
Isaac F Key Veteran Location: Panama Republic of Panama
I am pretty sure you was missing the Clutch Shoe.
The clutch bearings are 12mm and you fit the the Clutch Shoe there not the engine crank Shaft! Check this picture.
07-07-2002 Over year old.
gforce Veteran Location: Jacksonville FL
use the clutch luke, use the clutch. ok, ok, I see it now. the clutch inserts into the lower bearing by threading all the way onto the crankshaft. Thanks a million!!!
